AHCI vs SATA SATA is a Serial ATA interface that is meant to replace the aging PATA technology. It provides a lot of advantages compared to PATA, including faster data speeds.
![Sata Operation Ahci Or Ata Sata Operation Ahci Or Ata](/uploads/1/2/5/4/125428263/263584712.jpg)
Your computer will work just fine with the SATA controller set to ATA. What you miss by using ATA instead of RAID is the use of the AHCI interface. This interface is a bit more efficient than ATA and is necessary for setting up a RAID, but you probably will not notice the difference using a single drive. Modern systems usually offer different SATA Operation Modes such as ATA, AHCI or IRRT. The AHCI mode offers extra features such as hot swapping and native command queuing. Many vendors set the SATA Operation Mode to ATA by default because it’s the most compatible mode but there are a few reasons why you might want to change it.
The Advanced Host Controller Interface or commonly known as AHCI is a new programming standard that defines a new mode of operation for that adds two extra features; NCQ and hot-plugging. NCQ stands for Native Command Queuing, a feature that modifies the sequence in which data is retrieved. Instead of servicing each request sequentially like in traditional systems, it analyzes all the requests and plots out a path that takes the least amount of time to service all requests.
The result of this is somewhat uneven as although the total time is reduced, some of the earlier requests might be sent to the back of the list. Hot-plugging is a feature that doesn’t really improve the performance of the system but makes it easier and more convenient for users to add or replace disks. Hot-plugging simply allows users to remove or connect drives without needing to turn the whole system off; pretty much like a flash drive.
![Sata mode ahci or ata windows 7 Sata mode ahci or ata windows 7](https://pp.vk.me/c636423/v636423793/169de/dJ-0tAC_ZG8.jpg)
In order to maximize the compatibility of SATA to hardware that is being manufactured, manufacturers introduced a couple of modes of operation including AHCI and Legacy. Legacy IDE aimed to provide compatibility with older devices while foregoing the advanced functionalities that are available when using AHCI. Depending on the hardware that you have and its relative age, you might have a controller that does not support AHCI, thereby reducing your choices.
AHCI is a little bit more complicated to implement compared to your other choices with as it requires special drivers that needs to be installed. Even when switching to AHCI from an older installation that did not use AHCI can lead to problems as it is quite common for the motherboard to not recognize the drive and not boot your operating as it should.
There are steps that can be taken in order to make the transition a bit easier, though updating your hardware and operating system often solves the problem. SATA is a relatively new interface standard commonly used for storage media while AHCI is a programming interface that adds extra functionalities 2. AHCI introduces NCQ and hot-plugging capabilities 3. SATA can operate on IDE or AHCI 4. Certain hardware can support SATA without AHCI 5.
AHCI is a bit more complicated to implement.